Placeholder Image

Subtitles section Play video

  • Hello everybody, and welcome to another instructional video from Skookum Robotics.

  • In today's video, we're walking through the functions of the Futaba 8FG transmitter,

  • as they relate to the Skookum Robotics SK 720's Initial Setup Software.

  • Starting from the transmitter requirements in the initial setup wizard, you set your swashplate mode in the Linkage menu.

  • Access this menu by tapping theLNKbutton twice, then scroll down tomodel type’, then select the swash option.

  • 1- servo mode is called H-1 on Futaba radios.

  • Sub-trims are found in the linkage menu. Hit the LNK button twice, and scroll through the menu to the sub-trim option.

  • Adjust each channel until they read +0

  • The channel endpoints are also found in the linkage menu.

  • These are used to adjust the cyclic and tail gains if you haven’t set a locked value in your SK 720.

  • Scroll to the channel you selected to control your gains, and change the leftmost and rightmost value to set your gain value.

  • The left most number sets the upper switch position, and the rightmost number sets the lower switch position.

  • To change the bank each switch position controls, reverse that channel’s direction in theReversefunction,

  • also found in the Linkage menu.

  • If you need your transmitter’s auxiliary channels for another purpose,

  • you can lock the gain settings on the SK 720 software.

  • In the control tab, selectNONEin the Cyclic Gain Channel and Tail Gain Channel menus.

  • The Cyclic 2 and Tail 2 tabs disappear, and you can select a locked cyclic and tail gain setting.

  • The last function were going to look at in the linkage menu is the throttle cut.

  • This function is used when setting the throttle idle in the SK 720.

  • On an electric heli, set it to 0%. On a nitro, set it to a steady idle.

  • You can also select the switch controlling the throttle cut, using the SW menu at the bottom of the screen.

  • Dual Rates and Expo are found in the Model menu.

  • Hit the MOL button twice, and select Dual Rates.

  • Scroll through each channel, setting each value to 100.

  • You can also turn of any Expo in this menu by setting the value for each channel to +0.

  • You can also reset any throttle and pitch curves in the Model menu.

  • Starting with the pitch curve, the values going from top to bottom should be reset to 100, 50, 0, -50 and -100.

  • Moving on now to the throttle curve, you should reset the values, from top to bottom, to 100, 75, 50, 25, and 0.

  • As always, if you have any questions you can send us an email, or check the wiki using the links in the description. Thanks for watching.

Hello everybody, and welcome to another instructional video from Skookum Robotics.

Subtitles and vocabulary

Click the word to look it up Click the word to find further inforamtion about it