Name: [908] Corners Were Cut: Hyper Tough (Walmart) Deadbolt
Uploaded: 2020-03-30T06:06:04.000Z
Duration: 5 min 7 s
Description: Thousands of YouTube videos with English-Chinese subtitles! Now you can learn to understand native speakers, expand your vocabulary, and improve your pronunciation...

This is the lock picking lawyer, and what I have for you today is a hyper tough brand deadbolt.

Modal verbs - A2

Hyper tough is Wal Mart store brand, and they charge under $10 for this lock, so you can be pretty sure that some corners were cut.

Gerund

Of course, one of those corners is resistance to picking.

I think that was probably completely ignored here.

Single pin picking, raking, bumping, you name it.

It's probably going to work on this lock.

In fact, I'll pick it open for you in just a moment.

But picking isn't as common a threat in the real world as someone forcing your door kicking it in something like that.

So it's important to know how good this lock is at its design task of holding your door closed.

And they're one of the most important parts of the lock is the strike.

What I have here is a strike from a quick set deadbolt, not a super high quality locked, but certainly adequate In this department.

I can't bend that if I try and this is important, the screws that hold it in.

We have holes for four screws, and the two that are closest to the jam are very long.

In fact, they go all the way into the houses frame.

That's very important if you're going to resist force attacks.

So let's see what's in this hyper tough dead.

And let's take a look at the screws for this, Okay?

You can see the screws that hold that strike in.

Are these little short ones thes longer ones are what?

Hold the two halves of the dead bolt together.

So this is not going to resist a lot of force before it pulls out.

In fact, this alone makes this deadbolt a deal breaker.

Okay, let's see what it takes to pick into this lock.

It's not going to take nearly long enough for that to matter.

Do some top of the key way tension with a 50 thousands thick pry bar in a standard hook in 25 thousands.

Click out of one quick out of two, maybe a little something on three.

Okay, let's see what it, uh, what this lock has inside.

Peace cannot be removed non destructively.

And we can immediately see another corner that was cut.

This core has been cast, and they didn't even bother to drill the pinholes.

They just cast a rippled break in the middle of the corps.

Okay, that's being a little bit on the shy side.

Let me see if I can help these pins out with my pick.

What I mean by that is they both have the same.

The reason lock companies do that is it makes assembly very easy.

You don't have to worry about putting a keep it in upside down.

However, it also makes picking extraordinarily easy because it opens up a nice, wide sheer line.

Relatively certain these driver pins are all going to be standard.

At least I did not feel anything other than standard pins.

Cast housing, cast core, non drilled pin chambers.

All in all, this is a lot locked with a lot of corners that were cut.

It's not a surprise to me that this is a $10 lock.

In any case, that's all I have for you today.

If you do have any questions or comments about it, please put them below.

If you like this video and would like to see more like it, please subscribe.

Subtitles ListPlay Video

[908] Corners Were Cut: Hyper Tough (Walmart) Deadbolt

subscribe

tough

matter

trick